You are not logged in. Please login or register.
FIS-Control Forum → English forum → Zeitronix Ethanol sensor in fis-control?
Hello!
is it possible to get the ethanol level 0% to 100% in the fis control screen? I have a audi rs4 b5 2001. where should I plug it in and how does I program the fis-control to show it?
I have this ethanol sensor : http://zeitronix.com/Products/ECA/ECA2.shtml
Hi,
I can add this sensor in the next firmware. This sensor has two 5 volts outputs.
You can use the following inputs of the FIS-Control for them:
- Sensor 5
- Sensor 6
- Sensor 7
okey thanks! When you you fix that?
Maybe I have time for this during the weekend.
okey! I will plug it into sensor 5 and you can maybe reply here when the software is done so can I fix it. thanks!
Haha, just saw that I already have the ECA2 in the FIS-Control. Just select "ZT ECA-2" as sensor type.
How does I do that?
Connect the Zeitronix output to sensor input 5 of the FIS-Control.
Now go to SETTINGS -> SENSORS -> SENSOR 5 and select ZT ECA-2
Save the settings.
To view the measurement, go to SETTINGS -> CONTROL UNIT and select EXTERNAL SENSORS
Now you can start a MEASUREMENT. On the seconds block you should see the reading of the sensor.
Thank you!
FIS-Control Forum → English forum → Zeitronix Ethanol sensor in fis-control?
Powered by PunBB, supported by Informer Technologies, Inc.