Topic: Zadatec boost reading
Hi, I'm using zadaboost sensor to read above 1.55 bar with me7.5.
But it have a 0.1bar difference from the car MAP and other external gauge. The zadaboost reads always more 0.1bar.
Is this normal?
How can I solve it?
You are not logged in. Please login or register.
FIS-Control Forum → English forum → Zadatec boost reading
Hi, I'm using zadaboost sensor to read above 1.55 bar with me7.5.
But it have a 0.1bar difference from the car MAP and other external gauge. The zadaboost reads always more 0.1bar.
Is this normal?
How can I solve it?
Hi,
first make sure, that you connected the sensor to the correct input of the FIS-Control. This is input 5, 6 or 7.
Then you can check that the FIS-Control reads the correct voltage from the sensor.
Please got to SETTINGS -> SENSORS and select ADC-VOLTAGE so you can see the measured voltage.
Now you can measure the voltage of the sensor with a multimeter. The reading of the multimeter should match the reading of the FIS-Control.
Here you can see, how the FIS-Control converts the sensor voltage to the displayed boost:
http://www.fis-control.de/img/formula_15.png
Hi,
first make sure, that you connected the sensor to the correct input of the FIS-Control. This is input 5, 6 or 7.
Then you can check that the FIS-Control reads the correct voltage from the sensor.
Please got to SETTINGS -> SENSORS and select ADC-VOLTAGE so you can see the measured voltage.
Now you can measure the voltage of the sensor with a multimeter. The reading of the multimeter should match the reading of the FIS-Control.
Here you can see, how the FIS-Control converts the sensor voltage to the displayed boost:
http://www.fis-control.de/img/formula_15.png
I was testing it this morning. Zadaboost it's connected in sensor 5 input.
The voltage in the sensor cable it's the same reading in the dashboard.
What I've seen is that at 0bar it should do 1v and it's doing 1.04V . Sourcing 1bar with manual pressure pump, the pump gauge reads 1bar other external gauge reads 1bar and the zadaboost reads 2.08V 1.08bar...
This is more or less the difference I have between the MAP and zadaboost or the other external gauge that I have and the zadaboost sensor.
How can I correct it?
Ok, looks like the FIS-Control isn't doing anything wrong. If there is a problem with the Zadatech sensor, you might want to contact Zadatech directly: http://zada-tech.com/contact-us
FIS-Control Forum → English forum → Zadatec boost reading
Powered by PunBB, supported by Informer Technologies, Inc.