1 Topic by mokilok (edited by mokilok 2019-09-14 01:33:22)

  • Registered: 2019-09-13
  • Posts: 16

Topic: [resolved] FIS Control MMI shows no data

Hi Stefan,
I just bought the FIS Control MMI and installed it in the car without any issues. I have uploaded the newest firmware and all the other files. I have prepared and uploaded a configuration file, but there seems to be an issue:

*display shows no values at all*. The gauges have no needles, the list shows no values at all (just labels and units).
The clock is displayed on the status bar, so I think the device is properly connected.

Do I assume correctly that this is because of my ECM not being supported?

I have chosen:   EV_ECM20TFS0118K5907115_001010
But my car has: EV_ECM20TFS0118K5907115_001007 (the only difference are the last two digits in the ODX version)

Could this be the case? Please advise.

Post's attachments

Screenshot_20190910-175100.jpg 142.51 kb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.
Audi A5 B8.5 2.0 TFSI, MMI 3g+
  • From: Hessen / Germany
  • Registered: 2015-01-01
  • Posts: 2,070

Re: [resolved] FIS Control MMI shows no data

Maybe your ECU only supports to read 8 values at once. Please change the number of used formulas from 10 to 8 and try again.

stefan@fis-control's Website

  • Registered: 2019-09-13
  • Posts: 16

Re: [resolved] FIS Control MMI shows no data

That was it, with 8 values it works fine. Thanks!

Audi A5 B8.5 2.0 TFSI, MMI 3g+